English-Chinese Comparison of Agricultural Machinery

3.1.5 Clearing the stoppage in revolving 3.1.6 Relating to maintenance of diesel engine according to its booklet.Adding up Youlujing or diesel additive to make well after it works 50h ordinary load or 30th in heavy load 3.2 Regular technical maintenance 3.2.1 Finishing daily technical maintenance. 3.2.2 Cleaning gearbox and transmission case every 3 months or accumulative total operation 150h and exchang engine oil. 3.2.3 Checking all gear and bearing per year or accumulative total operation 1000h,exchanging them when they are necessary. 3.2 .4 Exchanging new parts when wear and tear of frictional piece reaches the limit. 3.2.5 Finishing the regular technical maintenance of diesel engine. 3.3 Long-term preservation 3.3.1 Cleaning engine oil and dirt oil in machine and pour into the new. 3.3.2 Cleaning surface of the machine. 3.3.3 Applying coat of grease or antirust oil on unpainted metal surface and every frictional part. 3.3.4 Preserving the machine in ventilating,dry,non-corrosive Gas and safe place indoor. 3.1.5 Troubleshooting found during operation 3.1.6 Maintenance of the diesel engine is to be carried out in accordance with the instructions of the diesel engine operating instructions. 50h for general load and 30h for heavy load, "oilpath net" or diesel king additive should be added to make diesel engine work better. 3.2 Regular Technical Maintenance 3.2.1 Complete the daily technical maintenance operations. 3.2.2 Clean the transmission and gear box every 150 months or cumulatively, and change the oil. 3.2.3 Check all gears and bearings every 1 year or cumulative use 1000h, replace new parts if necessary. 3.2.4 When the friction plate wears to the limit, it should be replaced with a new one. 3.2.5 Regular technical maintenance of diesel engines shall be carried out in accordance with the diesel engine instructions. 3.3 Long-term storage 3.3.1 Clear the engine oil and dirty oil, and inject new oil. 3.3.2 The entire surface cleaning and wipe clean. 3.3.3 Coat unpainted metal surfaces and friction parts with a grease (Lithium No. 2 lubricant) or rust preventive oil. 3.3.4 Store the machine in a ventilated, dry, non-corrosive atmosphere in a safe place.