Tractor safety turning tips

Tractor Safety U-Turing Tip The so-called tractor-turning is a 180-degree change in the direction of the tractor. How can we make the tractor safe for a U-turn? Here are two aspects of the selection of the turning point of the tractor and the basic operation method of the U-turn: (1) The choice of location The tractor should turn around and must strictly abide by the provisions of the road traffic regulations: At railway crossings, pedestrian crossings, curved roads, narrow roads, bridges, steep slopes, ramps, or road sections that are prone to danger, do not turn around. Therefore, it is necessary to choose a safe intersection with a small traffic intersection, flat, wide, and a strong shoulder; According to the width of the road and the traffic conditions, the tractor can change its head and turn the head once, or combine it with the reverse. If there is no such condition, you can also use the open space on the side of the road to turn the head. In the wider road, you should try your best to make a U-turn.This method is quick, convenient, economical, and safe.If there is a traffic commander, a U-turn signal is issued in advance and the permission of the commander is granted. After the gesture, reduce the speed and use the low speed gear, honking the sirens and driving the car to make a U-turn. If you have a narrow road, you can't turn around and you can use a combination of forward and backward turning.When you turn around, you must first select the right area and send a signal to turn left to drive the car slowly to the road. On the side, turn the steering wheel to the left. When the current wheel is approaching the roadside or the front edge of the vehicle approaches the obstacle, step on the clutch and gently step on the brake pedal. When the vehicle is not completely stopped, turn the steering wheel quickly to the right and turn the front wheel. To retreat to the desired new direction, immediately stop the vehicle.When you retreat, you should first observe the situation behind the car, then slowly start and turn to the right to the steering wheel, until the rear wheel will approach the roadside or tractor When approaching an obstacle, immediately step on the clutch pedal, lightly step on the brake pedal to stop, and use the timing before parking, quickly turn the steering wheel to the left, so that the front wheel turns to the new direction required for advancement. When you come in, you can make another retreat or advance, and repeat several times until the rotation is completed. When you turn around, in case of special circumstances (pitch or narrow road), no matter if you are going forward, backward or parking In addition to the use of foot brakes, hand brakes must be used to stop the car and then move gears forward or backwards.When operating, hold the steering wheel in one hand, hold the brake lever in one hand, and slowly release the clutch slowly. Pedal, and at the same time, a pedal pedal is properly refueled, when the majority of the clutch has been combined, the hand brake lever is relaxed, so that the tractor moves slowly and smoothly forward or backward. Retreat to leave room, because the distance between each wheel approaching the roadside is not equal, when judging the parking space, it should be based on the wheel approaching the roadside first. If there is any obstacle on the roadside, the bumper shall prevail. When retreating, you can use the rear compartment panel or the rear bumper, and do not touch the obstacles. When turning around in more dangerous locations, the rear of the vehicle should face toward the safe side and the front of the vehicle should face the risk side. Retire, do not overtake the roadside to ensure safety turn around.