Metal detector - needle detector fault conveyor belt troubleshooting

Metal detectors, needle detectors, common faults - cleaning steps and precautions for conveyor belts [Lianzhi new company original article prohibits reprinting] Because the needle detector is a highly sensitive detection instrument, the environment and machine maintenance are relatively Strict requirements. Usually after a period of use, the needle detector will have some common "faults", so normal use should be done regularly to clean the conveyor belt parts and other easily soiled parts. Cleaning methods and precautions are as follows:

1. Cleaning utensils: Find a clean towel, damp the water and wring it out until it can't be screwed out.

2. Cleaning the surface of the conveyor belt: Note that the sensitivity of the needle detector should be adjusted to the low level of Zui before cleaning. If the needle detector has B/C mode, please adjust the needle detector to C mode to avoid the sensitivity being too high. One step of cleaning work. Then straighten the towel and press it tightly on the surface of the conveyor belt, start the machine, and let the machine run for more than five rounds (the purpose is to clean the surface of the conveyor belt, the method can be used flexibly), then wash the towel and wring it out. Repeat this step again to wipe the conveyor belt until there is no obvious contaminant on the conveyor belt surface;

3. Clean the back of the conveyor belt: Then wash and wring the towel, pass the towel from the bottom of the machine to the bottom of the conveyor belt, straighten the towel, and pump the towel to the front of the conveyor. Grasp the two ends of the towel and start the machine to run the machine for several weeks. . Since the bottom of the conveyor belt is a dirty place, it is necessary to perform multiple wiping. After each operation for several weeks, the towel should be washed out and the above steps repeated.

3. How to judge the cleaning effect: After the above two cleaning steps, the needle conveyor belt adjusts the sensitivity to level 8 or high sensitivity, and starts the machine to let the machine run. If the machine runs smoothly and the probe metal position indicator light is not bright. At this time, the clothing without any metal impurities can be smoothly passed through the needle detector channel, that is, the conveyor belt is cleaned successfully!

After cleaning through the above steps, it is still found that the probe light does not stop after the power is turned on, and the clothes cannot pass smoothly, because the above cleaning steps are repeated again. At the same time, when cleaning the test work, it is necessary to avoid the surrounding interference environment factors, such as: personnel walking, too large a machine distance and other factors need to be considered!

Laser Distance Meter 50M

This 50m distance measuring meter is made of two parts: the laser distance outside unit and the sole part laser measure module. Great distance range is from 3cm to 50 meters with ±1.5mm high accuracy. Digital distance measuring device is quick and reliable measure with one hand pushing the button. It is designed for hand helding, very convenient to put in your jacket pocket or trouser pocket.
1>. Easy to Use. It is very easy to learn how to use a Laser Distance Meter, it can measure distance with pressing a single button.
2>. Safety. Using a laser distance meter to measure is much safer than using a measure tape, for users do not need to climb up and down.

50M Laser Distance Measurer,Mini Laser Measurer, Laser Measure 50M,50M Laser Distance Meter

Chengdu JRT Meter Technology Co., Ltd , https://www.rangesensors.com