Cleaning method for single filter cartridge dust collector

Cleaning method for single filter cartridge dust collector

The cleaning method of the filter dust collector is from the original manual cleaning to the electronic timer to clean the dust. Finally, we usually use the pulse control system to carry out the cleaning control, because the dust cleaning effect of the dust collector can be good or bad. An important factor that directly affects the performance of the precipitator, from the previous mechanical vibration, to the reverse airflow cleaning and pulse cleaning, while the pulse cleaning is often divided into automatic cleaning, high pressure gas pulse backflushing, and mechanical vibration. The mechanical vibration cleaning device is often used for small single-unit filter cartridge dust collectors, which use the shaking force generated by the eccentric device on the dust collector plate to perform cleaning, but this action needs to be stopped before operation. The pulse backflushing is to use a preset parameter of the controller to give a signal to the solenoid valve, and instantly open and close the diaphragm of the electromagnetic valve, so that the high-pressure gas enters the blowing pipe, and the dust on the surface of the filter cartridge is shaken off by the rapid expansion force of the gas. To carry out the cleaning process. It has the advantages of good cleaning effect, low equipment input cost and easy collection of dust.

Application range:

Hardware, cement, building materials, ceramics, electronics, chemicals, footwear, foundry, plastics, aluminum products, metallurgy, electricity, leather, food processing, machining, non-ferrous metals and other dust purification issues